Difference between revisions of "Global navigation satellite system (GNSS)"

From FIThydrowiki
Jump to navigation Jump to search
 
(One intermediate revision by one other user not shown)
Line 107: Line 107:
 
GNSS systems are used to georeferenced measurements. It is coupled with other systems, such as ADCP, Drones, devices for monitoring fish migration, and other devices where the exact location is nessary.  
 
GNSS systems are used to georeferenced measurements. It is coupled with other systems, such as ADCP, Drones, devices for monitoring fish migration, and other devices where the exact location is nessary.  
  
It is important to be aware of the accuracy of the GNSS data and if it fits the measurement. For bathymetry measurements it is recommended to have accuracy within a few cm, while discharge measurements can be done with accuracy at the submeter level.  
+
It is important to be aware of the accuracy of the GNSS data and if it fits the measurement requirements. For bathymetry measurements in small rivers and for analyses of low discharges it is recommended to have high accuracy, while a lower accuracy could be sufficient for bathymetry of large water bodies or measurements of high discharges.
  
 
There are mainly three different types of GNSS accuracy:
 
There are mainly three different types of GNSS accuracy:
#Standard, such as in cell phones and car navigation. The accuracy lies within 3-5 m horizontally and 5-20 m vertically. These systems don’t receive any correction signal.  
+
#Standard, such as in cell phones and car navigation. The accuracy is within 3-5 m horizontally and 5-20 m vertically. These systems don’t receive any correction signal.  
#Advanced receivers, usually referred to as “differential GPS”. These are used in most scientific instruments. The accuracy lies below 1 m horizontally and 2 m vertically.
+
#Advanced receivers, usually referred to as “differential GPS”. These are used in most scientific instruments. The accuracy is below 1 m horizontally and 2 m vertically.
#RTK-GPS need an internet connection to receive a correction signal. This usually is a real time signal (RTK = Real Time Kinematic), but it is also possible to get the correction for post processing.
+
#RTK-GPS need an internet connection or a local base station to receive a correction signal. This usually is a real time signal (RTK = Real Time Kinematic), but it is also possible to get the correction for post processing. Typical accuracy for the obtained position is in the range of 1 to 3 cm.
  
 
=Other information=
 
=Other information=
Line 129: Line 129:
  
 
=Contact information=
 
=Contact information=
 
 
[[Category:Methods]][[Category:Needs improvement]]
 

Latest revision as of 13:11, 30 September 2020

Quick summary

Figure 1: Differential GPS mounted on a remote-controlled boat for bathymetry and discharge measurements (Sweco).
Figure 2: RTK-GPS for single point measurements at very high accuracy (< 1 cm) (Sweco).

Developed by: USA, EU, China, Russia

Date:

Type: Methods

Suitable for the following Devices: Lidar, Particle image velocimetry (PIV), Acoustic Doppler current profiler (ADCP),

Introduction

Global navigation satellite system (GNSS) is a general term describing any satellite constellation that provides positioning, navigation, and timing (PNT) services on a global or regional basis. While GPS is the most prevalent GNSS, other nations have provided their own systems to provide complementary, independent PNT capability. GPS is often used as a synonym for all of the different systems (Table 1).

Table 1: Different systems called as GPS.

System

BeiDou

Galileo

GLONASS

GPS

Owner

China

European Union

Russia

United States

Coverage

Regional, global by 2020

Global by 2020

Global

Global

Status

Basic service by 2018, to be complete by H1 2020

Operating since 2016, 2020 completion

Operational

Operational

Precision

10 (public) 0.1m (encrypted)

1m (public) 0.01m (encrypted)

4.5m - 7.4m

15m (no DGPS or WAAS)

Application

GNSS systems are used to georeferenced measurements. It is coupled with other systems, such as ADCP, Drones, devices for monitoring fish migration, and other devices where the exact location is nessary.

It is important to be aware of the accuracy of the GNSS data and if it fits the measurement requirements. For bathymetry measurements in small rivers and for analyses of low discharges it is recommended to have high accuracy, while a lower accuracy could be sufficient for bathymetry of large water bodies or measurements of high discharges.

There are mainly three different types of GNSS accuracy:

  1. Standard, such as in cell phones and car navigation. The accuracy is within 3-5 m horizontally and 5-20 m vertically. These systems don’t receive any correction signal.
  2. Advanced receivers, usually referred to as “differential GPS”. These are used in most scientific instruments. The accuracy is below 1 m horizontally and 2 m vertically.
  3. RTK-GPS need an internet connection or a local base station to receive a correction signal. This usually is a real time signal (RTK = Real Time Kinematic), but it is also possible to get the correction for post processing. Typical accuracy for the obtained position is in the range of 1 to 3 cm.

Other information

General accuracy is depending on

  • Number of satellites / selective availability
  • Angle between the satellites = Dilution of Precision (DOP)
  • Reflection from buildings/obstacles = multipath error
  • Atmospheric conditions

Only the last point, the atmospheric conditions, can be corrected with the differential and RTK GPS.

Relevant literature

Contact information