Difference between revisions of "Shaft hydropower plant"

From FIThydrowiki
Jump to navigation Jump to search
(Created page with "right|150px|link=[[Downstream fish migration]] {{Note|This technology has been enhanced in the FIThydro project! See Innovative technologies fro...")
 
Line 32: Line 32:
  
 
=Other information=
 
=Other information=
TUM holds an EU patent for the IDA (EP3029203).
+
The HYDROSHAFT powerplant is protected by several patent families. Licences and engineering design support are exclusively provided by Hydroshaft GmbH, Goethestraße 43, 80336 München, Germany. (https://www.hydroshaft.com)
  
 
=Relevant literature=
 
=Relevant literature=

Revision as of 14:39, 9 October 2020

Icon downstream.png
This technology has been enhanced in the FIThydro project! See Innovative technologies from FIThydro for a complete list.

Quick summary

Figure 1: Schematic sketch of fish passage through a vertical axis Kaplan turbine without (left) and with (right) IDA device.
Figure 2: IDA pilot at the 35 kW Kaplan turbine intake at the TUM Lab with the two ring-shaped copper electrodes
Figure 3: Comparison of observed damage rates for fish passage without (blue) and with IDA pilot device (red) for varying fish lengths (total length TL) in the 35 kW pilot.

Date: 2020

Developed by: TU Munich, Chair of Hydraulic and Water Resources Engineering, Peter Rutschmann, Albert Sepp

Type: Device

Introduction

The HYDROSHAFT Powerplant is an innovative, fish-friendly hydropower concept, characterized by a horizontal rack, a submerged Kaplan turbine and a bypass for fish downstream migration immediately at the turbine intake. The hydropwer plant was originally developed to use existing non-gated weirs or ramps for hydropower generation. The HYDROSHAFT powerplant has a very simple geometry, doesn’t require a powerhouse and is therefore hardly visible or audible. It’s advantage for fish protection and ecology are the low velocities at the trash rack, the behavioral barrier through the horizontal fine-rack, the bypass for fish downstream migration and the possibility to pass all sediments over the shaft into the downstream.

Application

The HYDROSHAFT powerplant can use existing weirs or ramps but is also suitable to develop new hydropower at untouched rivers by the so-called multi-shaft concept. In the multi-shaft concept several shafts are combined with a so-called eco-migration corridor for fish and aquatic-sprecies migration. Due to its simple geometry the concept can be standardized and eventually prefabricate. Through the use of one or multiple shafts respectively the concept is scalable from small decentralized units up to large powerplants.

The powerplant has been extensively tested in the Lab of TU Munich in Obernach, where a 35kW pilot was built. Another equally sized pilot is situated at Voith Hydro in Heidenheim, Germany. The first larger powerplant is since February 2020 operational and feeds into the grid. It is located in Großweil, Bavaria, Germany at the Loisach River.

The HYDROSHAFT powerplant was tested in the Lab for its functionality, for the efficiency, for developing a suitable underwater trash-rack cleaner and for testing bypass migration routes and survival rates of fish. As a result of these investigations the following points are mentioned:

  • The overall efficiency (measured at the clamp to theoretical) was measured 87%
  • A completely new trash rack cleaner has been developed with MUHR HYDRO, Rosenheim, Germany
  • The bypass into the downstream was used by most fishes and therefore overall mortality of the concept is very low

Due to the experimentally proven high survival rates the first plant at the Loisach River in a Natura 2000 reserve was possible. Also at the Iller River the highest German administrative court supported the granted water right without amendment. Whereas the first plant at the Loisach River was constructed in a very classical way the efforts are now intensified to lower costs by standardization. The next powerplant at the Iller River, Bavaria, Germany, will already economically work without subsidies. The final goal is to reach a price of about 5 Euro-Cents per KWh.

Relevant mitigation measures and test cases

Relevant measures
Fish-friendly turbines
Relevant test cases Applied in test case?
Altheim test case -
Altusried test case -
Anundsjö test case -
Bannwil test case -
Bragado test case -
Gotein test case -
Guma and Vadocondes test cases -
Günz test case -
Ham test case -
Las Rives test case -
Schiffmühle test case -
Trois Villes test case -

Other information

The HYDROSHAFT powerplant is protected by several patent families. Licences and engineering design support are exclusively provided by Hydroshaft GmbH, Goethestraße 43, 80336 München, Germany. (https://www.hydroshaft.com)

Relevant literature

FIThydro deliverable D3.4 available at https://www.fithydro.eu/deliverables-tech/